Gia Long

Switch to desktop

What Is Decorative Concrete?

What Is Decorative Concrete?

What is decorative concrete? Ornamental concrete is basically concrete that has no real structure value. Its mainly for the aim of bettering property worth and eye appeal. Decorative concrete also makes it more easier to maintain. Concrete may be very porous and crumbly, so these things make it very unattractive.

Completely different kinds of decorative concretes are skim coats, overlays, stamped concrete, acid staining, alkaline staining, polishing, stain and polishing, and apoxie coatings. Skim coatings are usually 1/16 of an inch. They're made of Portland cement and totally different kinds of glue polymers. This would give your concrete surface a uniform and consistent look. Skim coats could be stained. They also can have stamping done to them and ornamental saw cuts. Skim coatings are considered an overlay.

Stamped concrete could be considered an overlay too. These begin off as a ¼ in. to ½ in. thickness. More prep work is required on the concrete earlier than the stamped overlay is done. The thickness of this would allow the stamping to take place. This may look like a brick road or enormous chunks of pure stones linked together. These may be stained any shade and usually must have a topcoat sealer.

Acid staining offers the concrete a deep and pure look. The concrete must thoroughly be cleaned of any glue, paint, grease, dust and left over thin set. One of the best ways to properly put together the concrete for this is to cut the ground surface with diamonds to a flat two-hundred grit surface. This will insure the concrete is open and the acid will penetrate the surface. Since acid etches and burns the concrete, it will be next to impossible to additional polish out the concrete. The acid must be neutralized and a topcoat sealer would be applied. These are often water-based acrylic, solvent-based acrylic, water- based acrylic urethane and solvent acrylic urethane. The acrylics by themselves are inclined to last years and acrylic urethane are inclined to last 5-7 years. All four sealers mentioned are breathable, which is Vidal for keeping you concrete in wonderful condition.

concrete acid etch staining is the simplest to do. Its especially good for model-new concrete. The prep work would involve mainly pressure washing at 2500 PSI and more than 180 degrees of scorching water. Hot water expands the concrete and permits the filth to depart so you may stain it. Cold water cracks the concrete. The precise technician can stain the concrete any color.

Concrete polishing is cutting the surface of the concrete until its perfectly flat. Polish begins off at four hundred grit surface. They will go as much as 3000 grit. 400 grits are usually for stores and may have little or no maintenance. 3,000 grit can be for high finish homes.
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.