Gia Long

Switch to desktop

What Is Decorative Concrete?

What Is Decorative Concrete?

What's decorative concrete? Decorative concrete is basically concrete that has no real construction value. Its primarily for the aim of improving property worth and eye appeal. Decorative concrete also makes it more easier to maintain. Concrete could be very porous and crumbly, so these things make it very unattractive.

Totally different sorts of decorative concretes are skim coats, overlays, stamped concrete, acid staining, alkaline staining, polishing, stain and polishing, and apoxie coatings. Skim coatings are normally 1/16 of an inch. They're made of Portland cement and totally different kinds of glue polymers. This would give your concrete surface a uniform and consistent look. Skim coats may be stained. In addition they can have stamping done to them and decorative saw cuts. Skim coatings are considered an overlay.

Stamped concrete could be considered an overlay too. These begin off as a ¼ in. to ½ in. thickness. More prep work is required on the concrete earlier than the stamped overlay is done. The thickness of this would allow the stamping to take place. This might appear to be a brick road or huge chunks of pure stones related together. These might be stained any coloration and usually need to have a topcoat sealer.

Acid staining provides the concrete a deep and pure look. The concrete must thoroughly be cleaned of any glue, paint, grease, dirt and left over thin set. The best way to properly prepare the concrete for this is to chop the commercial floor coating surface with diamonds to a flat two-hundred grit surface. This will insure the concrete is open and the acid will penetrate the surface. Since acid etches and burns the concrete, will probably be next to not possible to additional polish out the concrete. The acid must be neutralized and a topcoat sealer could be applied. These are often water-primarily based acrylic, solvent-based mostly acrylic, water- based acrylic urethane and solvent acrylic urethane. The acrylics by themselves are likely to final two years and acrylic urethane are likely to last 5-7 years. All 4 sealers mentioned are breathable, which is Vidal for keeping you concrete in excellent condition.

Concrete staining is the simplest to do. Its especially good for model-new concrete. The prep work would involve mainly pressure washing at 2500 PSI and more than a hundred and eighty degrees of scorching water. Hot water expands the concrete and permits the dust to leave so you can stain it. Cold water cracks the concrete. The fitting technician can stain the concrete any color.

Concrete polishing is chopping the surface of the concrete till its perfectly flat. Polish starts off at 400 grit surface. They will go up to 3000 grit. 400 grits are normally for stores and may have very little maintenance. 3,000 grit could be for high end homes.
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.